Horse Stall Design

stable design

Wooden stand, I love this design. Our gallery for horse boxes shows much of what we can do with a more traditional look. Which is the best design for horse stables, incl. stable building, flooring, walls, window and door?

You' re asking about the design of the pit stable, I suppose. There will be a range of different fabrics and styles that will work and finding the "best" design for one type of application may not be the best design for another. A little research has been done to determine what is "the best" when it comes to flooring, partitions, doorways, etc.

The best is the stable, which offers the horse and the horse owners a maximum of security, sufficient airing and convenience. The advantages and disadvantages of almost all types of floor coverings you can use, from grime to mattedcrete.

Firstly, most stables are laid out for a 12 foot x 12 foot stall. Indications are that a horse is more relaxed and better rested in a square stall, e.g. 10 ft x 14 ft or other large dimensions that give a square conform.

It seems that the horse can orientate itself more easily in a rectangle stable. That would be useful, because the horse itself has no quadratic form. Ideally, the stable is built in a stable with an inner avenue and an outer shell, so that the stable could have two entrances.

The apertures of both doorways would be 4 ft x 8 ft high. Like the stable floor, most stables have a loamy floor with a bed. In order to facilitate dewatering, the stands can be equipped with "French Drains". To do this, dig a post hole in the middle of the barn and two or more edges of the barn.

Excavated to a three to four foot deep, these boreholes are poured with rough gravels to a maximum of four to eight inch from the top of the pit and then ended with the soil with which the remainder of the stable finish.

These"' urinals " allow the water to flow out of the barn, so that you do not have such problems with damp areas and the removal of moist dirt when the barn is washed. Naturally, matting is often used as stable floor covering over clays or concretes or other stable floor coverings.

They work well as long as the stables have sufficient litter and the damp litter is cleaned every day together with liquid slurry. When it comes to stable walls, hard wood is probably the best. The use of cement or stone works very well if the stands are covered with a kind of wood kickboard up to a maximum of four-foot high.

At least eight to nine ft high stable wall. Minimal ceilings should be nine ft, but most referrals if there is a ceilings are higher to go, 10 to 12 ft again for ventilating purposes. However, if there is a ceilings, it is advisable to go higher. As far as aeration is concerned, a stable seal is advisable for warm climatic zones 20 inch above the ground with a width of 2 inch and a length of 7ft.

It is advisable to have a stable door six ft high and four ft x four ft if a stable has an outside panel. Naturally, it should have a grille or other kind of protection cover to prevent it from being broken by a horse. There is only one other thing to consider in stable construction: the movement of animals in and out to make them as effective as possible, and the movement of animals in relation to clearing the stables with whatever kind of machinery.

Mehr zum Thema